Peugeot 308 Key Fob Problems and How to Fix Them
If your Peugeot 308 key fob has stopped functioning one day, it could be due to a dead coin battery, water damage the receiver module or a faulty electronic chip. These are all easy solutions and you'll be able to get your car back up to speed in no time!
Car keys can also be damaged because the key blade gets worn. It is easy to fix this issue by visiting your local Car Key Man Auto Locksmith to install a new blade.
Battery
The key fob of your Peugeot 308 may die or become weak enough to not transmit a strong signal. The key fob may not function and stop you from locking or unlocking your doors or even starting your engine. To fix this, you'll need to replace the battery inside your key fob.
You'll need a new battery from an auto parts store or a local hardware store. Make sure the battery is brand new and not stored on the shelf too long. A brand new battery is more capacity and can transmit a stronger signal to your vehicle.
After replacing the battery After replacing the battery, try locking and unlocking the doors of your Peugeot with the key fob. If the doors don't unlock, the problem is likely to be in the receiver module of the car that can be reset by your local Peugeot dealer.
The internal chip of the key fob might be damaged. It is possible to harm your key fob if you drop it on the ground, or expose it to moisture. The rubber seals that protect the chip from moisture may be worn down over time, particularly if the key fob is exposed to water for prolonged periods of time, such as submerging it in the ocean at the beach. To prevent this from happening it is recommended to keep your key fob free of the reach of moisture and away from water.
Water Damage
If your key fob becomes wet, whether you dropped it into the pool or fumbled it into the puddle, don't believe that it's an accident. The key fob is protected by rubber seals but prolonged exposure to water could damage its electronic chip. Water is a good conductor, and any water that is absorbed into the key fob can cause the short circuits to be in series, which will eventually ruin the electronic chip. After removing the battery scrub its contacts with isopropyl Alcohol and dry it off completely before putting it back in.
Your Peugeot 308 may not start because of an unresponsive battery. If you have a spare car, jumper cables could be used to get the engine running again. If you suspect that the battery is at fault the battery will need to be replaced.
A poor receiver in the car could also block it from receiving the signal from the key fob. The key fob may be damaged, or there could be a problem with the antenna, wiring or key fob itself. If you're using a new key fob it may require to be programmed to the vehicle. If you are unable to solve the issue, you should contact an expert technician. A skilled technician will be able to find the issue quickly and correct it swiftly.
Radio Interference
For example, a keys not being recognized or having a narrow range usually indicate that there is a problem in the system. This is either radiated or conducted, with the latter resultant from power supply cables and speaker wiring that is too close to electrical components. Usually, rerouting the cables or moving them away from the components can solve the problem.
It's unlikely someone is listening to your key fob's signals in attempt to steal your vehicle It's possible, however, that radio interference has ruined the signal. Luckily, this is a simple issue to repair.
If you're experiencing a problem with your key fob not being recognized, try using an entirely new battery. Make sure that the battery is the right size and type. Batteries that are not of the correct dimensions can harm your battery.
These devices can interfere with the key signal if they use the same radio frequency. It is recommended to avoid using these devices with your key fob.
Pairing G28CarKeys that is used in the car is equipped with a receiver that receives radio frequencies from the key fob. If the receiver is experiencing a problem, you won't be in a position to begin your vehicle regardless of whether the key fob functions and is reset. The issue can be caused by a variety of ways, such as the battery of the coin-cell being dead or water damage. The receiver could also be malfunctioning due to a software issue or internal damage in the key.
One of the most frequent reasons for why your Peugeot 308 key fob is not working is because the battery inside has gone out of service. It is easy to replace it with a new battery, but it is important to choose the right battery for your key fob. A bad battery can cause more problems with the key fob, therefore it is best to choose the original battery or an equivalent replacement in size, voltage and specifications.
Your Peugeot 308 keyfob may not function if it was connected to an unrelated vehicle. It is possible that you have accidentally given your key fob away to a friend, or the key was used to unlock other vehicles. You can fix this by reprogramming the fob using an OBDII scanner. This tool will usually ask you for specific details about your vehicle, for example the VIN or engine type, so it's essential to enter this information correctly.